xStack DGS-3400 Series Fast Ethernet Switch
Access Profile Table
Configuring the Access Profile Table
Access profiles allow you to establish criteria to determine whether the Switch will forward packets based on the
information contained in each packet's header. These criteria can be specified on a basis of VLAN, MAC address or IP
address.
Creating an access profile is divided into two basic parts. The first is to specify which part or parts of a frame the Switch
will examine, such as the MAC source address or the IP destination address. The second part is entering the criteria the
Switch will use to determine what to do with the frame. The entire process is described below in two parts.
To display the currently configured Access Profiles on the Switch, open the
Configuration
folder and click on the
Access
Profile Table
link. This will open the
Access Profile Table
page, as shown below.
Figure 7- 40. Access Profile Table
To add an entry to the
Access Profile Table
, click the
Add
button. This will open the
Access Profile Configuration
page,
as shown below. There are four
Access Profile Configuration
pages; one for
Ethernet
(or MAC address-based) profile
configuration, one for
IP
address-based profile configuration, one for the
Packet Content Mask
and one for
IPv6
. You
can switch between the three
Access Profile Configuration
pages by using the
Type
drop-down menu. The page shown
below is the
Ethernet Access Profile Configuration
page.
Figure 7- 41. Access Profile Configuration (Ethernet)
120
Summary of Contents for xStack DGS-3427
