xStack DGS-3400 Series Fast Ethernet Switch
Figure 8- 14. Authentication Server Host Setting - Add window
Configure the following parameters to add an Authentication Server Host:
Parameter
Description
IP Address
The IP address of the remote server host to add.
Protocol
The protocol used by the server host. The user may choose one of the following:
TACACS
- Enter this parameter if the server host utilizes the TACACS protocol.
XTACACS
- Enter this parameter if the server host utilizes the XTACACS protocol.
- Enter this parameter if the server host utilizes the protocol.
RADIUS
- Enter this parameter if the server host utilizes the RADIUS protocol.
Port (1-65535)
Enter a number between 1 and 65535 to define the virtual port number of the
authentication protocol on a server host. The default port number is 49 for
TACACS/XTACACS/ servers and 1813 for RADIUS servers but the user
may set a unique port number for higher security.
Timeout (1-255)
Enter the time in seconds the Switch will wait for the server host to reply to an
authentication request. The default value is 5 seconds.
Retransmit (1-255)
Enter the value in the retransmit field to change how many times the device will
resend an authentication request when the TACACS server does not respond.
Key
Authentication key to be shared with a configured or RADIUS servers
only. Specify an alphanumeric string up to 254 characters.
Click
Apply
to add the server host.
NOTE:
More than one authentication protocol can be run on the same physical
server host but, remember that TACACS/XTACACS/ are separate
entities and are not compatible with each other
Login Method Lists
This command will configure a user-defined or default
Login Method List
of authentication techniques for users logging
on to the Switch. The sequence of techniques implemented in this command will affect the authentication result. For
example, if a user enters a sequence of techniques, for example TACACS - XTACACS- local, the Switch will send an
authentication request to the first TACACS host in the server group. If no response comes from the server host, the Switch
will send an authentication request to the second TACACS host in the server group and so on, until the list is exhausted. At
that point, the Switch will restart the same sequence with the following protocol listed, XTACACS. If no authentication
takes place using the XTACACS list, the local account database set in the Switch is used to authenticate the user. When the
local method is used, the privilege level will be dependant on the local account privilege configured on the Switch.
156
Summary of Contents for xStack DGS-3427
