xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Sw itch
15
Figure 2 - 5. Optional Module slots at the rear of the DGS-3627 (or DGS-3627G)
Figure 2 - 6. Optional Module slots at the rear of the DGS-3650
After removing the faceplate, remove the DEM-410X or DEM-410CX optional module from its box. The front panel should
resemble the drawings represented here.
Figure 2 - 7. Front Panel of the DEM-410X and the DEM-410CX
Take the module and gently slide it in to the available slot at the rear of the Switch until it reaches the back, as shown in the
following figure. At the back of the slot are two sets of plugs that must be connected to the module. Gently, but firmly push in on
the module to secure it to the Switch. The module should fit snugly into the corresponding receptors.
Figure 2 - 8. Inserting the optional modules into the Switch
Now tighten the two screws at adjacent ends of the module into the available screw holes on the Switch. The upgraded
DGS-3627/DGS-3627G/DGS-3650 is now ready for use.
Figure 2 - 9. DGS-3627 with optional module installed
Optional Module Slots
Optional Module Slots