xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
261
DGS-3627:5#create access_profile profile_id 4 ipv6 class flowlabel
Command: create access_profile profile_id 4 ipv6 class flowlabel
Success.
DGS-3627:5#
config access_profile profile_id (ipv6)
Purpose
Used to configure the IPv6 access profile on the Switch and to define specific values for the
rules that will be used to by the Switch to determine if a given packet should be forwarded or
filtered. Masks entered using the
create access_profile
command will be combined, using a
logical AND operational method, with the values the Switch finds in the specified frame
header fields.
Syntax
config access_profile profile_id <value 1-14> add access_id [auto_assign | <value 1-
128>] ipv6 {class <value 0-255> | flowlabel <hex 0x0-0xfffff> | source_ipv6 <ipv6addr> |
destionation_ipv6 <ipv6addr>} port [<portlist> | all] [permit {priority <value 0-7>
{replace_priority} | rx_rate {no_limit | <value 1-156249>]} | counter [enable | disable]} |
mirror | deny} | {time_range <range_name 32>}
delete access_id <value 1-128>]
Description
This command is used to define the rules used by the Switch to either filter or forward packets
based on the IPv6 part of each packet header.
Parameters
profile_id <value 1-14>
−
Enter an integer between
1
and
14
that is used to identify the
access profile that will be configured with this command. This value is assigned to the access
profile when it is created with the
create access_profile
command. The lower the profile ID,
the higher the priority the rule will be given.
add access_id <value 1-128>
−
Adds an additional rule to the above specified access profile.
The value specifies the relative priority of the additional rule. Up to 128 different rules may be
configured for the IPv6 access profile.
auto_assign
– Choose this parameter to configure the Switch to automatically assign a
numerical value (between
1
and
128
) for the rule being configured.
