xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
291
config dst
Parameters
disable
– Disable the DST seasonal time adjustment for the Switch.
repeating
– Using repeating mode will enable DST seasonal time
adjustment. Repeating mode requires that the DST beginning and ending
date be specified using a formula. For example, specify to begin DST on
Saturday during the second week of April and end DST on Sunday during
the last week of October.
annual
– Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
October 14.
s_week
– Configure the week of the month in which DST begins.
<start_week 1-4,last>
– The number of the week during the month in which
DST begins where 1 is the first week, 2 is the second week and so on, last
is the last week of the month.
e_week
– Configure the week of the month in which DST ends.
•
<end_week 1-4,last>
– The number of the week during the month
in which DST ends where 1 is the first week, 2 is the second week
and so on, last is the last week of the month.
s_day
– Configure the day of the week in which DST begins.
•
<start_day sun-sat>
– The day of the week in which DST begins
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat)
e_day
– Configure the day of the week in which DST ends.
•
<end_day sun-sat>
– The day of the week in which DST ends
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat)
s_mth
– Configure the month in which DST begins.
•
<start_mth 1-12>
– The month to begin DST expressed as a
number.
e_mth
– Configure the month in which DST ends.
•
<end_mth 1-12>
– The month to end DST expressed as a
number.
s_time
– Configure the time of day to begin DST.
•
<start_time hh:mm>
- Time is expressed using a 24-hour clock, in
hours and minutes.
e_time
– Configure the time of day to end DST.
•
<end_time hh:mm>
– Time is expressed using a 24-hour clock, in
hours and minutes.
s_date
– Configure the specific date (day of the month) to begin DST.
•
<start_date 1-31>
– The start date is expressed numerically.
e_date
– Configure the specific date (day of the month) to begin DST.
•
<end_date 1-31>
– The end date is expressed numerically.
offset [30 | 60 | 90 | 120]
– Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are
30
,
60
,
90
, and
120
.
The default value is
60
.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch:
