xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
3
2
U
SING THE
C
ONSOLE
CLI
The Switch supports a console management interface that allows the user to connect to the Switch’s management agent via a serial
port and a terminal or a computer running a terminal emulation program. The console can also be used over the network using the
TCP/IP Telnet protocol. The console program can be used to configure the Switch to use SNMP-based network management software
over the network.
This chapter describes how to use the console interface to access the Switch, change its settings, and monitor its operation.
Note: Switch configuration settings are saved to non-volatile RAM using the
save
command. The current
configuration will then be retained in the Switch’s NV-RAM, and reloaded when the Switch is rebooted. If
the Switch is rebooted without using the save command, the last configuration saved to NV-RAM will be
loaded.
Connecting to the Switch
The console interface is used by connecting the Switch to a VT100-compatible terminal or a computer running an ordinary terminal
emulator program (e.g., the
HyperTerminal
program included with the Windows operating system) using an RS-232C serial cable.
Your terminal parameters will need to be set to
:
•
VT-100 compatible
•
115200 baud
•
8 data bits
•
No parity
•
One stop bit
•
No flow control
Users can also access the same functions over a Telnet interface. Once an IP address has been set for the Switch, users can use a
Telnet program (in VT-100 compatible terminal mode) to access and control the Switch. All of the screens are identical, whether
accessed from the console port or from a Telnet interface.
After the Switch reboots and you have logged in, the console looks like this:
DGS-3627 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.50.B15
Copyright(C) 2009 D-Link Corporation. All rights reserved.
UserName:
PassWord:
DGS-3627:5#_
Figure 2- 1. Initial Console Screen after logging in
Commands are entered at the command prompt,
DGS-3627:5#
.
There are a number of helpful features included in the CLI. Entering the
?
command will display a list of all of the top-level
commands.
