xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
94
Command Parameters
show stp
show stp ports
{<portlist>}
show stp instance_id
{<value 0-15>}
show stp mst_config id
Each command is listed, in detail, in the following sections.
enable stp
Purpose
Used to globally enable STP on the Switch.
Syntax
enable stp
Description
This command allows the Spanning Tree Protocol to be globally enabled
on the Switch.
Parameters None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To enable STP, globally, on the Switch:
DGS-3627:5#enable stp
Command: enable stp
Success.
DGS-3627:5#
disable stp
Purpose
Used to globally disable STP on the Switch.
Syntax
disable stp
Description
This command allows the Spanning Tree Protocol to be globally disabled
on the Switch.
Parameters None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To disable STP on the Switch:
DGS-3627:5#disable stp
Command: disable stp
Success.
DGS-3627:5#
