xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
The following parameters can be configured.
Parameter Description
Loopdetect Status
Use the drop-down menu to enable or disable loopback detection. The default is
Disabled.
Loopdetect Trap
None
– The trap will not be sent in any situation.
Loop Detected
– The trap is sent when the loop condition is detected.
Loop Cleared
– The trap is sent when the loop condition is cleared.
Both
– The trap will be sent for both conditions.
Interval (1-32767)
Set a Loopdetect Interval between
1
and
32767
seconds. The default is
10
seconds.
Recover Time
(0 or 60-1000000)
Time allowed (in seconds) for recovery when a Loopback is detected. The Loopdetect
Recover Time can be set at
0
seconds, or
60
to
1000000
seconds. Entering
0
will
disable the Loopdetect Recover Time. The default is
60
seconds.
Mode
Select the mode
you wish to use either
Port Based
or
VLAN Based.
Port Based
– This mode can detect loopback based on the Port. If the Switch detects
loopback on the Port, the loopback detection will only block the traffic which belongs
to this Port. Other VLAN traffic should not be affected by this.
VLAN Based
– This mode can detect loopback based on the VLAN. If the Switch
detects loopback on the VLAN, the loopback detection will only block the traffic which
belongs to this VLAN. Other VLAN traffic should not be affected by this. Loopback
detection will send the CTP packets periodically per port per VLAN in VLAN-based
mode.
Unit
Select the unit you wish to configure.
From/To
Use the drop-down menu to select a port or range of ports to be configured.
State
Use the drop-down menu to toggle between
Enabled
and
Disabled.
Click
Apply
to implement changes made.
131
