xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
setting is
Disabled
. If no number is supplied, the default value of three times is used.
Allowas In Value (1-
10)
Enter an Allowas In Value between
1
and
10
.
Default Originate
State
Enable or disable the default originate function. By default, this setting is
Disabled
.
Route Map Name
Enter a Route Map Name of a maximum of 16 characters.
EBGP Multihop (1-
255)
Enter the TTL of the BGP packet sent to the neighbor. For an EBGP neighbor the default
setting is 1. This means only direct connected neighbors are allowed.
Weight (0-65535)
Enter a value for weight. The valid range is from
0
to
65535
. If this is not specified, the routes
learned through another BGP peer will have a default weight of 0. Routes sourced by the
local router have a weight of 3768. It cannot be changed.
Update Source
Enter an interface to be used by BGP sessions for TCP connection. By default, this
parameter is not set.
BGP Neighbor Timer Settings
IP Address
Enter the IP address of the neighbor to be configured.
Peer Group Name
Enter the peer group to be configured.
Advertisement
Interval (0-600)
Enter the interval at which the BGP process sends update messages to its peer. The valid
value is from
0
to
600
. If this value is set to zero, the update or withdrawn message will be
sent immediately. The default value for IBGP peers is 5 seconds and for EBGP peers it is 30
seconds. When the default check box is ticked, the neighbor specific advertisement interval
setting will be returned to the default setting.
Keep Alive (0-65535)
Enter the interval at which a keepalive message is sent to its peers. If the two routers, that
build a BGP connection, have different keepalive timers, the smaller keepalive timer will be
unset. The valid value is from
0
to
65535
. If the keepalive is set to zero, then the keepalive
message will not be sent out. By default, the timer is not specified. This neighbor specific
setting will follow the global setting.
Hold Time (0-65535)
The system will declare a peer as dead if not receiving a keepalive message until the hold
time. If two routers, that built a BGP connection, have different hold times, the smaller hold
time will be used. The valid value is from
0
to
65535
. If the holdtime is zero, then the holdtime
will never expire. It is recommended that the holdtime value is three times that of the
keepalive timer. By default, the timer is not specified. This neighbor specific setting will follow
the global setting.
AS Origination
Interval (1-600)
Enter the minimum interval between the sending AS origination routing updates. The valid
value is from
1
to
600
. The default setting is
15
seconds.
Connect Retry
Interval (1-65535)
Enter the minimum interval BGP sends TCP connect requests to the peer after a TCP
connection fail happens. The valid value is from
1
to
65535
. The default setting is
120
seconds.
Click
Apply
to implement changes made.
281
