xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 7- 25. 802.1X Port Settings window (Modify)
This window allows users to set the following features:
Parameter
Description
Unit
Select the unit to configure.
From/To
Enter the port or ports to be set.
AdmDir
Sets the administrative-controlled direction to either
in
or
both
.
If
in
is selected, control is only exerted over incoming traffic through the port you selected in
the first field.
If
both
are selected, control is exerted over both incoming and outgoing traffic through the
controlled port selected in the first field.
Port Control
This allows you to control the port authorization state.
Select
forceAuthorized
to disable 802.1X and cause the port to transition to the authorized
state without any authentication exchange required. This means the port transmits and
receives normal traffic without 802.1X-based authentication of the client.
If
forceUnauthorized
is selected, the port will remain in the unauthorized state, ignoring all
attempts by the client to authenticate. The Switch cannot provide authentication services to
the client through the interface.
If
Auto
is selected, it will enable 802.1X and cause the port to begin in the unauthorized
state, allowing only EAPOL frames to be sent and received through the port. The
authentication process begins when the link state of the port transitions from down to up, or
when an EAPOL-start frame is received. The Switch then requests the identity of the client
and begins relaying authentication messages between the client and the authentication
server.
363
