xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
NOTE:
The user must first globally enable 802.1X in the
DGS-3600 Web
Management Tool
window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1X.
Reauthenticate Port(s)
This window allows reauthentication of a port or group of ports by using the pull-down menus
From and To and clicking
Apply
.
The Reauthenticate Port Table
displays the current status of the reauthenticated port(s) once
Apply
has been clicked
.
To view this window, click
Security > 802.1X > Reauthenticate Port(s)
, as shown below:
Figure 7- 31. Reauthenticate Port window
NOTE:
The user must first globally enable 802.1X in the
DGS-3600 Web
Management Tool
window before initializing ports. Information in the
Initialize Ports Table cannot be viewed before enabling 802.1X.
To reauthenticate ports for the MAC side of 802.1X, the user must first enable 802.1X by MAC address in the
DGS-3600 Web
Management Tool
window.
Click
Security > 802.1X > Reauthenticate Port(s)
as shown below:
Figure 7- 32. Reauthenticate Port(s) window (MAC-based 802.1X)
To reauthenticate ports, first choose the switch in the switch stack by using the pull-down menu and then choose the range of ports
in the From and To field. Then the user must specify the MAC address to be reauthenticated by entering it into the MAC Address
field and ticking the corresponding check box. To begin the reauthentication, click
Apply
.
This window displays the following information:
Parameter Description
Unit
Select the switch to configure.
From/To
Select the range of ports to reauthenticated.
369
