xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
SNMP Host Table
Use this window to set up SNMP trap recipients. To delete an existing SNMP Host Table
entry, click the corresponding
button
under the Delete
heading.
To view this window, click
Administration > SNMP Manager > SNMP Host Table
, as shown below:
Figure 2- 76. SNMP Host Table window
Users now have the choice of adding an IPv4 or an IPv6 host to the SNMP host table. To add a new IPv4 entry to the Switch's
SNMP Host Table, click the
Add IPv4 Host
button in the upper left-hand corner of the window. This will open the
SNMP Host
Table Configuration
window, as shown below:
Figure 2- 77. SNMP Host Table Configuration window for IPv4
The following parameters can set:
Parameter Description
Host IPv4 Address
Type the IPv4 address of the remote management station that will serve as the SNMP host
for the Switch.
SNMP Version
V1
- This specifies that SNMP version 1 will be used.
V2
- To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv
- To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv
- To specify that the SNMP version 3 will be used, with an Auth-NoPriv
security level.
V3-Auth-Priv
- To specify that the SNMP version 3 will be used, with an Auth-Priv security
level.
Community String or
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
To add a new IPv6 entry to the Switch's SNMP Host Table, click the
Add IPv6 Host
button in the upper left-hand corner of the
window. This will open the
SNMP Host Table Configuration
window, as shown below:
70
