xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
697
Chapter 63
Modify Login Banner
and Prompt Commands
config greeting_message
{default}
show greeting_message
config command_prompt
[<string 16> | username | default]
63-1
config greeting_message
Description
This command is used to modify the login banner.
Format
config greeting_message {default}
Parameters
default
– (Optional) Adding this parameter to the config greeting_message command will return
the greeting message (banner) to its original factory default entry.
Restrictions
When users issue the
“reset” command, the modified banner will remain in tact. Yet,
issuing the “reset system” will return the banner to its original default value.
The maximum character capacity for the banner is 24 lines with 80 characters per line.
In the following example, Ctrl+W will save the modified banner only to the DRAM. Users
must enter the “save” command to save this entry to the Flash memory.
Only Administrator and Operator-level users can issue this command.
Example
To edit the banner:
DGS-3620-28SC:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
===============================================================================
DGS-3620-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.015
Copyright(C) 2012 D-Link Corporation. All rights reserved.
