The front panel of the Switch features a Management portwhich can be used to connect to
a computer using a standard Ethernet cable. A web browser or Telnet client can be used to
connect to the Switch using the MGMT port.
The default IP address of the Management port is 192.168.0.1, and a subnet mask of
255.255.255.0. Make sure that the computer being used for Switch management has a
nonconflicting IP address in the 192.168.0.x subnet.
The IP settings or enabled status of the Management port can be changed through the
console port. To change the configuration of the Management port, use the command:
To view the status or IP settings, use the command:
To change settings for the out-of-band Management port in the web interface, use the
following path:
10
Connecting to the Management Port
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway <ipaddr>}
show out_band_ipif
Management > Out of Band Management Settings
Logging onto the Web Manager
To access the Web User Interface the user simply runs the standard web browser and enter
the Switch’s IP address into the address bar of the browser and press the
Enter
key. To
access the Web UI from normal LAN ports, the user needs to configure an IP address for
this interface first before it can be accessed via the Web User Interface.
The PC must have an IP address in the same subnet as the switch. For example, if the switch
has an IP address of 10.90.90.90, the PC should have an IP-address of 10.x.y.z (where
x/y is a number between 0 ~ 254 and z is a number between 1 ~ 254), and a subnet mask
of 255.0.0.0. Open the web browser and enter 10.90.90.90 (the factory-default IP address
in the address bar. Then press
Enter
.
Additional Information
For more detailed information on how to set up and configure the DGS-3620-52P,
please refer to the D-Link Website .
http://www.dlink.com/
Summary of Contents for xStack DGS-3620-52P
Page 22: ...22 ...
