TO Start and OFF
：
Press the switch ON/OFF on the front panel.
IMPORTANT : DO NOT turn the Footspa “ ON” unless adequate water is
in the tub. THE WARRANTY IS VOLD WHEN THE PUMP HAS BEEN
RUN WITHOUT ADEQUATE WATER. DO NOT BLOCK THE JETS
DURING WHIRLPOOL OPERATION.
To Drain
：
Do not drain the tub until the pump is OFF and has completely stopped.
Turn the overflow waste control value to drain the water from the tub.
Cleaning and Care of The Footspa
----------------------------------------------------
Thorough cleaning is key. Good care requires both cleaning the basin after
each customer and flushing the entire system periodically. How often the
system needs flushed depends largely on your volume. Be careful not to use
anything that could scratch or gouge the surface, as those places can become
breeding grounds for bacteria.
Drain all water and remove debris from the Footspa.
Flush out your spas on a regular basis with clear water. Let the whirlpool
run for 10-15 minutes then drain the tub.
Clean the surfaces and walls of the Footspa with soap or detergent with
clean, clear water then wipe dry with a clean towel.
It is also a good idea to remove the filter screen over the whirlpool inlet
regularly and wash it with a chlorine solution.
Spot clean with mild soap and water for chair seat cleaning.
Page 4 of 5
