www.securemme.it | E-mail: info@securemme
8
D-SMART INSTALLATION
Before you proceed, fully recharge the ba ery (un l the led on the charger becomes green).
1.
Make a cut in the inner panel as shown in fig. 1, having dimensions of 50 x 105 mm, to housing the motor unit. Cut
out the paper template available on page 18 and place it on the inner door panel. On the external panel prepare a 20
mm hole only if you have the external numeric keypad—transponder reader, insert the cable from the external side to
the internal cut and connect the cable to the circuit board in posi on 3 (see page 6).
2.
Use a cylinder with knob predisposi on ( preferably a Securemme one) and make sure that the size is correct.
3.
For a correct opera on of the product, the lubrifica on of the stem in the rota on area is recommended.
4.
Install the cylinder on the lock and fix it.
Fig. 2
Fig. 3
Fig. 4
Fig. 1
m
in
. 5
2
m
m
Handle hole
Internal side
