11
Micro-iDT™
PLUS
Series
collars are equipped with
rechargeable Nickel Metal Hydride (NiMH) batteries,
which are not memory sensitive and do not require
depletion before recharging. Although batteries come
partially charged from the factory, it is recommended
that they are given a full charge (about 12 hours)
before initial use.
The transmitter uses a 9-volt replaceable battery (not
included). Be sure to pay attention to the “+” and “-”
charges when inserting the battery.
NOTE
Rechargeable batteries typically last about 2-5 years on
average depending on use and care. Keep batteries away
from flammable substances. See
page 17
for more infor-
mation on battery maintenance.
CHARGING THE COLLAR BATTERIES
Battery Charging Procedure
1. Make sure the unit is off.
2.
Plug the charger into a
standard electrical outlet.
3. Connect the splitter cable to the charger and plug
an end into the Collar Receiver. The SmartLED
should light solid
red
while charging.*
4. Charging is complete when the SmartLED turns
green
(may take up to 12 hours).
5. As soon as charging is complete, disconnect the
battery charging cable from the receptacle, securely
replace the rubber receptacle cover, and test unit.
WARNING: DO NOT CHARGE WHILE UNIT IS WET!