14
To Test the Vibration:
1. Press Vibrate Button on the transmitter and the col-
lar unit will vibrate only.
Before testing, make sure that both units are fully
charged and the power to the Collar Receiver is “ON”.
To Test the Electronic Stimulation:
1. Place the tester firmly on the contacts
of the Collar Receiver.
2. Set the intensity (note - an intensity
level setting of 4 or less might not be
enough to light the tester).
3. Push the ‘NICK’ or ‘CONT’ button.
4. The tester light will quickly flash once when the Nick
button is pushed and light repeatedly when the
Continuous Stimulation button is pushed (the test
light will be brighter at higher intensity levels).
TESTING
To Test the Jump:
1. Press Jump Button on the transmitter and test light
brightness will reflect the user-programmed Jump
level (see
page 19
).
2. The intensity level will return to its original setting
when the Jump button is released.
NOTE:
If the collar unit is not responding to any signals
from the transmitter, the collar may need to be repro-
grammed to the transmitter (see
page 16
).
11
SmartLED
**
Charging Error
- If the SmartLED has a long blink every other
second while charging, the rechargeable battery pack may need to
be replaced. New batteries may also initially give an error light.
Contact D.T. Systems if the problem persists after a few charging
sessions.
R.A.P.T. Series
collar units are equipped with the SmartLED
battery status system. The SmartLED system lets you know when
the unit is charging and when the charging is complete. It also
gives you a status on how much charge is remaining in the battery
during use, when it needs charging, and when the batteries will
need to be replaced.
Action
LED COLOR/
PATTERN
Status
Charging
(collar only)
Red
Charging
Green
Charging complete*
Long
Red
blink every
other second
Charging error**
Flashing
Green
51%-100% charge left
Flashing
Red
21%-50% charge left
Red
double flash or
rapid flash
Battery charge is low and
requires charging soon
While Unit
is On
(collar only)
*
Charging Complete
- Once charging is complete, your unit will
go into a trickle charge to prevent overcharging. However, it is
recommended that you remove your unit from the charger as soon
as charging is complete.
Transmitter Battery Indicator
- The LED lights while pressing
any of the Transmitter buttons. The LED flashes rapidly after
pressing a button if the battery is low.
Summary of Contents for R.A.P.T. 1400
Page 1: ......
