Page
20
of 61
SK2019 FCSD 1V-01-EC-001_1
Electrical Connection
It is recommended using screened cable in electrically noisy areas.
Do not install fan coil unit in a location
where electromagnetic waves may be directly emitted towards infra-red receiver
on the unit.
Install the unit and components as far away as is practical (at least 5m) from any electromagnetic wave source.
Use shielded sensor cable in where electromagnetic waves exist.
Install a noise filter if necessary.
Always take safety precautions before wiring for mains supply. See section B.1. for Safety Precautions.
One standard power cord (optional), two auxiliary contacts for outdoor unit or Electric Heater, one window contact, one
wired wall pad contact and two cooling / heating valve plugs are integrated with PCB.
Refer to Section D and F for Control PCB configurations and wiring diagrams.
