Page
29
of 61
SK2019 FCSD 1V-01-EC-001_1
Fan Coil Unit ON/OFF
There are 3 ways to turn the system on or off:
a)
By the ON/OFF button on the remote handset or wired wall pad;
b)
By the programmable timer on the handset or wired wall pad.
c)
By the manual control button on fan coil unit.
Auto Restart
The system uses a non-volatile memory to save the present operation parameters when the system is turned off
or in case of system failure or cessation of power supply.
The restored parameter data-set depends on the type of user interface.
a)
Handset only user interface:
When the power ON signal is received by the fan coil unit and no wired wall-pad is installed, the Mode, Fan Speed,
Set temperature and Louver setting will be the same as the handset setting before the last power OFF.
b)
Wall-pad only OR wall-pad and handset user interface:
When the power ON signal is received by the fan coil unit and a wired wall-pad is installed, the Mode, Fan Speed,
Set temperature, Louver setting and Timer ON/OFF weekly program will be the same as the wall pad setting
before the last power OFF.
