DAITSU RHR-CFULL WIRELESS CONTROL
The Daitsu RHR-CFULL wireless control is a user and insta-
llation interface for monitoring and configuring the connec-
ted heat recovery unit.
• This unit allows the quality of the indoor air to be con-
trolled by varying the fan speed.
• The device uses a wireless connection (RF) to commu-
nicate with the central unit (heat recovery unit).
SPECIFICATIONS
A
OK button
B
Back button
C
+ / Up button
D
- / Down button
E
Menu button
Binding the ventilation unit (VU)
and the wireless multi-control unit
1.
Press the MENU button for 10 seconds until the configuration
menu icon appears .
2.
If the unit is not bound, by pressing the MENU button again, the
binding icon will appear
. Then press the OK button.
3.
The icon starts to flash when searching for the VU.
a. If it is bound correctly, the screen shows BND.
b. If it is not bound correctly, the screen shows NO BND.
4.
If necessary, you can exit by tapping the BACK button to return to
the configuration menu, or to go back to the home screen.
IMPORTANT:
the VU will be visible for binding for 10 minutes after
it is connected to the power supply. If the binding has not occurred
in 10 minutes, the VU must be restarted by disconnecting it from
the power supply and reconnecting it so that it is available again for
binding for 10 minutes.
Selecting the mode and the ventilation speed
From the home screen, the ventilation speed can be changed immedi-
ately by pressing the + and – buttons.
Speed
High
At home
Low
Absence
Icon
AUTO
AUTO
AUTO
AUTO
Once high speed is reached, if you press the + button, the AUTO in-
dication lights up, showing that you are in automatic speed selection
mode (regulated by probes or timing).
If the AUTO indication does not appear, you are in manual speed
selection mode.
By pressing the + button again, you will enter the timer mode. An in-
dication icon will appear on the screen in the form of an hourglass .
Icons on the LCD screen
A
Timer mode.
B
Maximum mode.
C
Absence mode.
D
Change filter / Reset filter.
E
Fan speed.
It can be seen in one of these 4 icons:
Speed
High
At home
Low
Absence
Icon
AUTO
AUTO
AUTO
AUTO
F
AUTO
mode of the ventilation unit.
When AUTO is not shown, the fan speed is in MANUAL mode.
G
Display of 4-digit real value.
H
Display of 2-digit real value.
I
Fault indicator (it can be combined with other icons).
J
Configuration mode.
K
Link mode.
L
Time setting menu.
M
“On” program enabled / “Off” program disabled.
N
Programming activation periods.
O
Days of the week.
P
Bypass indicator.
If you are not on the default screen, tap the
BACK
button.
AUTOMATIC MODE
ABSENCE MODE
To start
ABSENCE
mode, tap the
UP
button or
DOWN
button over
and over until the icon lights up.
To start
AUTO
mode, tap the
UP
button or the
DOWN
button over
and over until the
AUTO
icon lights up.
MANUAL MODE
When in
AUTO
mode, use the
UP
button or the
DOWN
button to
stop
AUTO
mode. Tap the
UP
or
DOWN
button over and over to select
the correct speed of the ventilation unit.
MAXIMUM MODE
To start
MAXIMUM
mode, tap the
UP
button or the
DOWN
button
over and over until the icon lights up.
TIMER MODE
To start
TIMER
mode, tap the
UP
button or the
DOWN
button over
and over until the icon lights up.
A
B
C
K
J
I
H
G
F
E
D
L
M
N
O
P
