background image

3

Installation

Method 1 (Screens 80" And Smaller  

In Viewing Width)

Method 1 (Screens 80" And Smaller  

In Viewing Width)

There are four methods of installation based on the size of the 
screen and type of viewing surface. Measure the width of the 
viewing area of your screen and refer to the appropriate method 
of installation below. The wall bracket diagram shows the type 
and quantity of bracket(s) supplied based on the size of the 
screen.

Method 1: Screens 80" and smaller in viewing width.

Method 2: Screens over 80" up to 96" in viewing width.

Method 3: Screens over 96" in viewing width.

Method 4: Any size screen with High Power® viewing surface.

1.  Secure the wall bracket to wall studs at the desired height. 

Make sure the bracket is level. The top of the frame will be 
1/8" above the top of the wall bracket when mounted. You will 
need at least 5/8" clearance above the bracket to hang the 
screen. Figures 2, 3, and 4 show the proper orientation for the 
supplied wall brackets.

2.  To install the lower wall bracket, you must measure the 

overall height of the screen frame and subtract 1-3/8". Using 
that dimension, measure down from the top edge of the wall 
bracket and mark the wall for two screw holes. The holes 
should be centered within the frame and 6" apart. Refer to 
Figure 3.

3.  Attach the small wall bracket to the wall. Refer to Figure 4 for 

proper orientation. Do not tighten the screws completely. The 
bracket should slide up and down easily.

4.  Unroll the screen on a clean surface. Do not use newspaper. 

The viewing side is rolled to the inside of the roll. Place the 
frame over the screen surface, and while lifting the frame 
with one hand, snap the screen surface onto the frame  
with the other hand while maintaining a steady pull  
on the surface.

5.  Hang the screen on the brackets by hooking the bottom of 

the frame onto the lower wall bracket and lift up until you can 
hook the top of the frame on the top bracket. Push down on 
the frame to seat it on the brackets. Refer to Figure 4.

Figure 2

Small Wall Bracket
1-Piece

Figure 3

Large Wall 
Bracket
1-Piece

Large Wall Bracket

6"

Small Wall Bracket

Overall Height Less 1 3/8"

Overall 

Height

Figure 4

2

Lift

1

3

W

all

Summary of Contents for Cinema Contour Screen









Reviews: