5
Figure 3
Magnet
Trim
Cover
Trim
Cover
Safety
Screw
Figure 4
Case Installation (continued)
5.
Test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. To prevent damage to the motor,
the standard duty cycle is 1 minute on and 3 minutes off.
6. Install finishing trim covers on both ends of the case. Line
up trim cover flush with case (Figure 3). Magnet will hold
cover in place and secure with safety screw #2 Phillips
screwdriver through motor and pin end bracket (Figure 4)
7.
Install access door. Slide motor end of door onto mounting
post (Figure 5). Lift up slat on pin end side and hook door
onto pin end mounting post (Figure 6).
8. Rotate access door upward and push until you hear springs
latch into door bracket (Figure 7). There are three
attachment points, motor end, pin end and center.
NOTE:
If the center latch does not engage, press inward on
flange at the center latch position and rotate access door
upward. The slot in door must be positioned between the
case and the clip (Figure 8).
Door
Mount
Post
Figure 5
Figure 7
Door
Mount
Post
Figure 6
Slat
Figure 8
Access
Door
Center
Hanging
Bracket
Flange
(Front of
Case)
Clip
