Da-Lite DESIGNER ELECTROL, Instruction Book

Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly!

CAUTION!

 Do not cut wrapping paper or tape with knife or any sharp tool. Pull orange string.

  1.  Carefully unpack the screen and remove the outer wrapping.
  2. 

Always handle screen in upright position.

  3.   Remove the front cover of the screen from the back of the screen. Lift front cover up approximately 1/2" and pull 

away from back of screen. See Figure 1.

  4.  There are two methods of mounting the screen: suspended from ceiling and wall mounted. See Figure 2.

  NOTE:

 Allow 1/2" above screen (when mounted) for front cover of screen installation and removal.

  5.   Picture surface is centered in case. Case extends 5-1/2" beyond surface on either end. Do not attach anything to 

screen slat on the bottom of the screen.

PRE-INSTALLATION

s

!

HANGER BRACKET

HANGER

PIN

FRONT

COVER

BACK OF

SCREEN

PICTURE

SURFACE

PICTURE

SURFACE

PICTURE SURFACE
SLAT

CEILING

WALL MOUNTING

CEILING MOUNTING

PLACE “D”

RINGS OVER

HOOKS WELL

SECURED IN

CEILING.

FIGURE 1

FIGURE 2

“V” BAR mOUNTED 

TO THE WALL

WALL

“V” BAR 

mOUNTED TO 

THE BACK OF 

THE CASE AT 

THE FACTORy

ALLOW A mINImUm OF 

1-1/4" FROm CEILING

2