Da-Lite ViewShare Advantage Electrol Retrofit, Instruction Book

4

Pre-Installation of ViewShare Screen and Roller Assembly

1.  Remove existing motor and pin end roller assembly brackets 

from inside the case.

NOTE:

 At this point the inside of case will be empty except for 

the junction box connections on the motor end.

2.  Remove a single circular knockout from motor end of case for 

CAT5 cable needed in the Installation of ViewShare Screen and 
Roller Assembly (Figure 4).

 NOTE:

 The CAT5 cable should be run from the Local CAT5 to 

USB Extender in Camera and Speakerphone Installation to this 
location. Final connection of this CAT5 cable running through the 
knockout will occur in Step 10 of Installation of ViewShare Screen 
and Roller Assembly.

3.  Place the two spacing gaskets (shown in Figure 5) on the bracket 

bolts with 1/4” – ½” of the bolts showing through the bottom 
(Figure 6).

4.  Slide the motor end spacing gasket until it makes contact with 

the end of the case (Figure 7).

5.  Slide the pin end spacing gasket until it is approximately 1 ½ 

inches from the end of the case (Figure 8).

6.  Carefully unpack the new ViewShare screen and roller assembly 

and set aside. Be sure to leave the packing paper on the roller.

NOTE:

 If your screen and roller assembly was ordered with a 

new motor, please proceed to “Installation of ViewShare Screen 
and Roller Assembly”. If you are utilizing your existing motor, 
please continue to “Transfer of Existing Motor”.

Figure 4

Figure 5 – Spacing Gaskets

Figure 6

Figure 7

Figure 8

Circular
Knockouts 
for CAT5 
Cable

Spacing 

Gasket

1/4" to 1/2" of 

bolt showing

Motor End 

Gasket

Motor End 

Spacing

Gasket

Pin End 

Spacing

Gasket

1 ½ in.

Pin End 

Gasket