ENGLISH
104
GB
Use the key “1” for the orientation of the in
-
Use the key “1” for the orientation of the in
-
terface panel as described in par 2.2.2. If the
terface panel as described in par 2.2.2. If the
key is lost or damaged, the operation can be
key is lost or damaged, the operation can be
done using a standard 2mm allen wrench.
done using a standard 2mm allen wrench.
Once the 2 plastic keys have been separat
-
Once the 2 plastic keys have been separat
-
ed they can be used by inserting “2” in one
ed they can be used by inserting “2” in one
of the holes “B” in key “3”: whichever hole is
of the holes “B” in key “3”: whichever hole is
most convenient, depending on the opera
-
most convenient, depending on the opera
-
tion. At this point you obtain a multifunction
tion. At this point you obtain a multifunction
cross key, with a use corresponding to each
cross key, with a use corresponding to each
of the 4 ends.
of the 4 ends.
Figure 22
A
C
D
B
F
2
1
3
E
To use the cross key you must put the unused key “1” away in a
To use the cross key you must put the unused key “1” away in a
safe place so that it does not get lost, or else put it back in its seat
safe place so that it does not get lost, or else put it back in its seat
inside key “3” at the end of operations.
inside key “3” at the end of operations.
Use of end “C”:
Use of end “C”:
this is practically a straight tip screwdriver of the correct size for manoeu
-
this is practically a straight tip screwdriver of the correct size for manoeu
-
vring the caps of the main connections of the system (1” and 1”1/4). To
vring the caps of the main connections of the system (1” and 1”1/4). To
be used at the first installation to remove the caps from the mouths on
be used at the first installation to remove the caps from the mouths on
which you want to connect the
which you want to connect the
system; for the filling operation in
system; for the filling operation in
the case of horizontal installation;
the case of horizontal installation;
to access the non-return valve,
to access the non-return valve,
… If the key is lost or damaged,
… If the key is lost or damaged,
the same operations can be per
-
the same operations can be per
-
formed using a straight tip screw
-
formed using a straight tip screw
-
driver of a suitable size
driver of a suitable size
..
Use of end “D”:
Use of end “D”:
hexagonal socket head suitable for re
-
hexagonal socket head suitable for re
-
moving the cap to perform filling in the
moving the cap to perform filling in the
case of vertical installation. If the key is
case of vertical installation. If the key is
lost or damaged, the same.
lost or damaged, the same.
Figure 23
Figure 24
Figura 25
Summary of Contents for e.sybox Series
Page 3: ......
