ENGLISH
48
Type of depth sensor
Indicate the type of depth sensor.
Refer to our DAB catalogue for the choice of values.
When first installed, the key is inhibited, as entering a value is mandatory.
Tank height
Set the height of the tank at your disposal, which cannot be higher than the full scale value of the sensor.
The choice of values ranges from a minimum of 0.5 m / 1.6 ft to a maximum of 30 m / 98.4 ft.
Configuration with protection levels
With the depth sensor, it is possible to set a maximum level alarm for "overflow" and a minimum level alarm for
"dry run".
If floats for "overflow" and "empty tank emergency" have already been provided, these
inhibit the alarms set with the depth sensor.
The decision to provide both protections is for greater system safety.
Then proceed to set the levels for each pump.
MINIMUM LEVEL ALARM
To be set only if Configuration with protection levels is
selected on the previous page.
PUMP 2 LEVEL
PUMP 1 LEVEL
STOP PUMPS
MAXIMUM LEVEL ALARM
To be set only if Configuration with protection levels is
selected on the previous page.
Once the control type has been configured, see section 8.3.4 Concluding configuration.
8.3.2
Floats
Indicate floats as the type of control.
Once you have made your choice, then indicate the polarity of your floats.
Once the control type has been configured, see section 8.3.4 Concluding configuration.
