Radiographic image scanner EAGLE.PS
55
EQUIPMENT OPERATION
Important:
A filter or adjustment can be applied to the image as necessary for its better visualization, being no
restrictions to the amount applied.
Perform Measurements
Measurement icons enable the operator to perform Line and Angle Measurements on an image.
Figure 56 - Measurement icons
Measurement types
Line:
Represents the Measurement of the distance straight in any way or direction in the image. The
Measurement unit must be 'mm' (millimeter), with an accuracy of 2 (two) decimal places. It can also be
drawn consecutive lines, here called "Multiple Reads".
Angle:
Represents the Measurement of an angle between two consecutive straight lines. The
Measurement unit should be 'degrees', with an accuracy of 2 (two) decimal places.
Remarks:
Edit Measurement:
By clicking on this icon, the system will provide a tool that will allow the operator to
move one of the Measurement points, migrating it to a new location, and in parallel, the new measured
value will be displayed.
Hide:
By clicking on this icon, the system will hide the Measurements made in the image, that is, it will not
display the Measurements that were drawn in the image.
Display:
Clicking this icon will display the Measurements that were drawn on the previously hidden image.
Undo Last note:
Clicking this icon will erase the last Measurement that was performed on the image.
Exclude All:
By clicking on this icon, the system will display a confirmation message and, if the operator
confirms, erase all the Measurements that were performed on the image.
Calibrate Measure:
Clicking on this icon will pop up the system according to Figure 57, allowing the
operator to calibrate the actual measurement and pixel measurement performed on the image.
Erase Any Measure:
When performing this action, the system will display a confirmation message and, if
the operator confirms, Erase is the only Measurement selected. This action is performed only by selecting
Measurement and pressing the "Delete" button on the Keyboard.
Calibration:
For imported images, Retrieved and edited the actual measurement is "Zero".
Summary of Contents for EAGLE.PS
