2
Corporate Headquarters, Sales & Manufacturing:
Dabir Surfaces, Inc., 7447 West Wilson Ave., Harwood Heights, IL 60706, USA, www.dabir-surfaces.com
Sales Inquiries:
sales@dabir-surfaces.com, Tel: +1(888)559-3641
Technical Support:
support@dabir-surfaces.com, Tel: +1(888)559-3642
PATENT:
www.dabir-surfaces.com/patents
DOC# R02-0006-00014-DA
System Installation - Surface Connections
11. Insert Surface connector as shown.
12. Listen for an insertion “CLICK” to confirm proper connection.
NOTE:
Therapy will start automatically if powered “ON”.
Surface
Connector
Controller Operation: “ON”, “OFF” and “PAUSE” Mode
13. POWER “ON”:
Touch and hold the “POWER” key until the “START-UP”
screen appears. Therapy will automatically begin if a Surface is connected.
System Starting
SW vXXX.X.XX
Getting familiar with the Controller User Interface:
75%
933
HRS
933
HRS
MICROPRESSURE
933
HRS
HIGH
LOW
CYCLE
SPEED
SURFACE
"MICROCLIMATE"
Feature NOT available
at this time
"MICROPRESSURE"
"LOW" and "HIGH"
alternating cycle speeds
"POWER"
"ON", "OFF" and "PAUSE"
"SELECT"
"MENU" confirmation and
"KEY LOCK" mode
STEPS 11 & 12:
Connector Insertion
WARNINGS / CAUTIONS:
•
Therapy is NOT provided unless the Controller is powered “ON” and the Surface is actively cycling.
Quick Set-Up Guide - Continued
16. “KEY LOCK” MODE “ON” / “O
FF”:
Touch and hold the "SELECT" key
for 4 seconds to “LOCK” display. (Yellow lock symbol will appear.)
Touch and hold the “SELECT” key for another 4 seconds to
“UNLOCK” the display. (Yellow lock symbol will disappear.)
RESUME
RESUME IN XX:XX MINUTES
SYSTEM PAUSED
14.
POWER “OFF”:
Touch and hold the “POWER”
key until the “OPTIONS” Menu appears. Select
“SHUTDOWN” by touching “POWER” key for 2
seconds.
15. “PAUSE” MODE:
Touch and hold the “POWER”
key until the “OPTIONS” screen appears, then
select “PAUSE” to temporarily stop therapy.
(Default is 30 minutes.) Select “RESUME” at
anytime to immediately resume therapy.
STEP 13:
Power Controller “ON”
SELECT OPTION
SHUTDOWN
RESUME
PAUSE
(Hold 2 seconds)
NOTE:
For C2-1002 Models, the User Interface has been simplified. To change cycle speed, press the “DOWN” key