DAC Monitoring and Control System
User Manual Data Logger and Tower Meter
DL-PDL_General-User-Manual
_ve_2-0-2.docx
Page 12
During the installation, the Monitoring System facilitated guides has to be followed. If
situation occur which are not described and covered by the user manual, DAC System
has to be contacted immediately before any further actions are taken.
For the proper installation the required special tools must be used.
Before any installation starts it should be make sure that a first aid kit is on site available
and the emergency telephone number is known to the onsite personnel.
Use the Monitoring System products and components only for the described purpose
and within the parameters specified in the data sheets.
Safety indication
Switch-off of the broadcast service, transmitters and/or amplifiers before installation starts.
7 Special tools
For the correct installation of the hybrid connector Han-Brid the following tools are required:
Tool
Supplier Part-No.
Comment
Crimptool Harting
Crimp tool Harting,
for Han-Brid
electrical contacts,
Part.-No.
09990000110
The Harting crimp tool is used to crimp the
electrical contacts of the hybrid cable, -/+ 48V.
Tool set
Leoni
FOC mounting tool
supplier LEONI,
Part-No. ZXST-
KW0ZXHPPCF
The crimp tool and diamant cutter are used to
mount the HP connector to the two (2) PCF
fibres.
Required material for the Han-Brid connector on the
DL/PDL side
and JB 2.0:
CJB-01-FOC – Male
Supplier Harting, Part-No.
Comment
19370031443
Han 3A Hood Top Entry M20 Black - DL/PDL side (metal)
19000005084
Cable clamp M20, 6-12m (metal)
09120042606
Han 4Brid-M-c + 2LWL-M-HCS-c (K)
09150006101
Han D M Crimp Contact Ag 1,5 QMM-AWG16
JB 2.x: not produced anymore
Required material for the Han-Brid connector on the
JB 3.x
:
CJB-01-FOC – Male
Supplier Harting, Part-No.
Comment
19407030410
Han 3HPR Top Entry M20, Rohs conform (metal)
19620005084
Han Cable Gland M20x1.5 D9-13mm (metal)
