9
HIGH
position
HIGH
position
LOW
position
LOW
position
Installation Instructions
Verifying Proper Operation
WARNING
•
Make sure that power to the electrical outlet is turned
off at the circuit breaker panel or fuse box and that
the gas is turned off at the gas supply valve before
proceeding.
•
The cooktop must be properly grounded at all times
when electrical power is applied.
Prior to operating the cooktop, read the accompanying use
and care manual carefully.
1. Make sure all the cooktop burner controls are in the
OFF
position.
2. Connect the power cord to the electrical outlet.
3. Turn on power to the electrical outlet at the circuit
breaker panel or fuse box.
4. Push down and turn the left front burner control knob
slowly counterclockwise to the
HIGH
posi-
tion. The corresponding burner indicator light
should come on. Verify that the burner igniter
sparks, then return the knob to the
OFF
position. Repeat for all of the remaining
control knobs.
5. Turn on the gas supply valve.
6. Perform the following ignition test for all of the burners,
one at a time:
•
Push down and turn the control knob slowly coun-
terclockwise to the
HIGH
position. All of the burner
igniters will spark. It may take up to 4 seconds for
the burner to ignite, at which time the igniters will
stop sparking. If ignition does not occur within 4
seconds, turn the knob to the off position. Wait for
at least 5 minutes to allow any gas to dissipate,
then repeat the test.
•
Once the burner lights, rotate the control knob
counterclockwise from
HIGH
to
LOW
to adjust the
flame height progressively. On the SimmerSear
burner, only the center of the burner should be lit
when the knob is in the low position.
•
When the unit is installed properly, the flame will
be steady. It will
also have a sharp,
blue inner cone
that will vary in
length proportional
to the burner size.
The flame will be
reduced by the
Smart Flame™
feature under the
grate fingers to
increase grate life.
NOTE: If the cooktop does not operate properly, follow
these troubleshooting steps:
•
Verify that power and gas are supplied to the cooktop.
•
Check to make sure that the power plug is connected
to the electrical outlet and that power is turned on at
the circuit breaker panel or fuse box.
•
Check to make sure that the burner parts are properly
seated.
•
If the burner continues to spark after ignition without
stopping, have a licensed electrician check the electri-
cal outlet for proper grounding or reversed polarity.
•
Repeat the above burner ignition test.
•
If the appliance still does not work, contact Dacor
Distinctive Service at (877) 337-3226. Do not attempt
to repair the appliance yourself. If you need service, be
sure to have the model and serial numbers available
when you call. See inside cover for location.
Dacor is not responsible for the cost of correcting problems
caused by a faulty installation.
Standard Burner Control Knob
SimmerSear Control Knob (Center)
HIGH
position
Normal Flame Appearance
Summary of Contents for DCT365/NG
Page 1: ...Installation Instructions Distinctive Series Cooktop Model DCT365 Part No 106927 Rev A...
Page 14: ...12 Notes...
Page 15: ......
