Step-by-step installation
The installation procedure may differ depending on the model.
STEP 1
Select a location
Select a location that meets the following conditions.
• The location must have a solid floor that can support the weight of the dishwasher.
• The location must be near a sink (9.8 ft/3 m) with easy access to the water supply,
drain system, and electrical outlet.
• The location must let you load dishes into the dishwasher easily.
• The location must have sufficient space for the dishwasher door to open easily
and provide enough space between the dishwasher and the cabinet sides (at least
0.1 inch/2 mm).
• The rear wall must be free of obstructions.
Installation in a new location
A
B
If you install the dishwasher in a new
location, follow these instructions before
installing the dishwasher.
1.
Using a hole saw, cut a hole into the
side of the cabinet that holds the sink
(A)
.
2.
If the base inside the sink cabinet is
raised above the kitchen floor and is
higher than the connections on the
dishwasher, make a hole in the base
inside the cabinet and in the cabinet
side
(B)
.
NOTE
• If you are replacing an old dishwasher,
check the existing connections for
compatibility with the new dishwasher
and replace the connections as needed.
• You may need to cut a hole in the
opposite side of the cabinet according
to the location of the electrical outlet.
English
18
Ins
tallation
Installation
DD68-00250L-00_IB_DACOR_DW8700B_EN.indd 18
2024-01-11 3:09:27
