STEP 5
Install the custom panel
A
1.
Insert the supplied
rubber skirt (A)
into
the 3 holes at the bottom of the door.
Ø 2
~
12
2.
Put the installation template on the
back of the custom panel and fix it
temporarily using transparent tape.
Note that the rear of the custom panel
will be attached to the dishwasher door.
CAUTION
• The top end of the custom panel must
be aligned with the top end of the
installation template.
• Use a custom panel between 9-44 lbs.
3.
Pre-drill the 12 points marked on the
installation template using a 2-pi drill
bit to a depth of
3
/
8
-
1
/
2
" (10-12 mm).
B
B
C
C
4.
Remove the installation template and
tighten the
Custom panel fixers - Top
(B) / Custom panel fixers - Bottom (C)
at
the top with
12 screws (C, Ø4 X 16)
as
shown.
CAUTION
Be sure to check the direction of the
Custom panel fixers -
Top (B)
/
Custom
panel fixers - Bottom (C)
before installing.
English
23
Ins
tallation
DD68-00250L-00_IB_DACOR_DW8700B_EN.indd 23
2024-01-11 3:09:29