ENGLISH
12
Installation
Installation instructions
We recommend that a qualified technician install the
hood. It is the installer’s responsibility to ensure the hood
complies with the installation clearances specified for the
product.
• It is recommended that the vent system be installed
before the hood is installed.
• If possible, disconnect and remove any cooking
appliance from beneath the hood area to provide
easier access to the rear wall.
• Before making cutouts, make sure there is proper
clearance within the ceiling or wall for the exhaust
vent.
•
Confirm that all installation parts have been removed
from the shipping carton.
1. Turn off the power at the circuit breaker panel or fuse
box.
2.
Determine which venting method to use: roof or wall
exhaust.
NOTE
This hood is factory set to vent through the top air exit.
3.
Select a flat surface for assembling the hood. Place a
covering over that surface.
Outside top exhaust
Top installation diagram
Use the diagram or the hood as a template and mark the
locations for the ductwork, electrical wiring and keyhole
screw slots.
Top view of the hood
A
D
C
B
E
FRONT OF THE HOOD
5
1
⁄
4
”
(13.3 cm)
5
1
⁄
4
”
(13.3 cm)
WALL
3
⁄
4
” (19 mm)
10
1
⁄
2
”
(26.6 cm)
CENTERLINE
30"
36"
48"
A
30" (76 cm)
36″ (91.2 cm)
48" (121.7 cm)
B
12″ (30.5 cm)
C
1″ (2.5 cm)
D
2 ⁵⁄₈″ (6.5 cm)
E
7 ¹⁄₂″ (19 cm)
Rear installation diagram
Use the diagram or the hood as a template and mark the
locations on the wall for electrical wiring and keyhole
screws slots.
Back view of the hood
Ø 1”
2.5 cm
B
B
A
C
C D
E
E
F
G
H
I
TOP OF THE
HOOD
J
D
CENTERLINE
BOTTOM OF THE HOOD
30"
36"
48"
A
30" (75.5 cm)
36″ (90.6 cm)
48" (121.1 cm)
B
9 ¹³/₁₆" (25 cm)
C
3 ¹⁵/₁₆" (10 cm)
D
3 ⁵/₈" (9.2 cm)
E
3 ⁷/₁₆" (8.7 cm)
F
2" (5 cm)
G
3 ¹/₄" (8.2 cm)
H
3 ¹¹/₁₆" (9.3 cm)
I
11 ³/₈" (28.9 cm)
J
9 ⁵/₈" (24.5 cm) 12 ⁵/₈" (32 cm)
18 ⁵/₈" (47.3 cm)
Summary of Contents for DHD U990C/DA Series
Page 59: ...ESPA OL 59 Notas...