15
Installation Instructions
Refrigerator Door Panel Installation
1. Attach the refrigerator door panel to the refrigerator
face by hooking the six (6) brackets on the back of the
custom panel over the adjustment studs on the door
face. During installation, the adjustment brackets on the
top of the panel need to be inserted into the slots at the
top of the door face.
2. Place a washer on one of the hex bolts. Hand thread
it into one of the holes in the top of refrigerator door.
Thread it half way. Do the same for the other hole.
Final Panel Alignment
1. Align the freezer drawer panel vertically and horizontally
by adjusting the bolts on the underside of the freezer
drawer face using the hex wrench (included).
Align the refrigerator door panel vertically and
horizontally by adjusting the bolts on the top of
the refrigerator door face using the hex wrench.
To Adjust the Depth of the Panels
1. Push the magnetic seal aside on the back side of the
refrigerator door face and the freezer drawer face to
expose the adjustment holes.
• There are 3 sets of adjustment holes on each side of the
refrigerator door and 2 sets of holes on each side the
the freezer drawer. See diagrams below.
2. Insert the hex wrench into the holes labeled
ADJUSTMENT and turn to adjust the panel depth.
3. Lock the the panel into place by inserting the hex
wrench into the holes labeled LOCK and turning each
set screw clockwise until it stops. See diagrams below.
IMPORTANT
To ensure the doors shut correctly, pull the magnetic seals
back into position so that they are straight.
Top of refrigerator door
Bottom of
freezer drawer
Top of refrigerator door
Magnetic seal
Panel Depth Adjustment (Freezer)
Panel Depth Adjustment (Refrigerator)
Magnetic seal
