8
Planning the Installation
Self-Rimming Installation With
Downdraft Vent
•
Only model DR30DI may be installed with a downdraft vent.
Use only Dacor downdraft vent model ERV3015.
•
A self-rimming countertop configuration is required for
downdraft vent installation. On installations with a downdraft
vent, when sliding the range into position, it will stop when the
rear of the control panel or side panels contact the notches
toward the front of the countertop.
•
The self-rimming installation of the DR30DI range and
ERV3015 downdraft vent create a “built-in” look where the
range trim overlaps the countertop on both sides and the
downdraft vent overlaps the countertop in back. It is also
possible, if the cabinets are deep enough, to self rim the front
of the range into the cabinet face immediately behind the
control panel and door trim or behind the side panels (see
side views on this and the facing page). The rear range trim
will partially cover the front of the downdraft vent chassis in
back.
Model DR30DI
Range and
ERV3015
Downdraft Vent
With
H
J
K
Countertop self-
rimmed only
20 5/8”
(52.4 cm)
0” (0 cm) to
3 1/4”
(8.3 cm)
0” (0 cm) to
5 3/8” (13.7 cm)
Countertop and
Cabinet Front
Self-Rimmed
,
20 5/8” *
(52.4 cm)
NA
0” (0 cm) to
5 3/8” (13.7 cm)
Countertop and
Cabinet Front
Self-Rimmed (side
panels removed)
23 7/8” *
(60.6 cm)
NA
0” (0 cm) to
2 1/8” (5.4 cm)
* Cabinet face below countertop must be flush with back of notch
in countertop.
Countertop height for all self-rimming installations:
35 7/16” (90.0 cm) minimum, 37 7/16” (95.1 cm) maximum
IMPORTANT:
If the 3 1/4 inch side panels are removed, the
cabinet face must be flush with the back of the control panel.
rear wall recommended
Non-combustible
countertop opening
cabinet opening
below countertop
29 1/4” (74 3 cm)
27 1/2” (69.9 cm)
30” (76.2 cm)
2 5/8”
(6.7 cm)
10” min.
(25.4 cm)
both sides
Countertop height: min: 35 7/16” (90.0 cm) max: 37 7/16” (95.1 cm)
Notch countertop
overhang to width of
cabinets
3/8” min. (1.0 cm)
countertop
overhang
downdraft vent opening
H
Combustible side
wall above range
below countertop
To cabinet face
To countertop
front
J K
Model DR30DI/ERV3015 Countertop Self-Rimmed Only,
Cabinet Depth: 23 5/8” to 26 7/8”
(Without 3 1/4 Inch Side Panels Installed)
Top View
Side View
Cabinet face
Countertop
Back of
control
panel
DR30DI[H] range
3/8” min. (1.0 cm) flat countertop
overhang required behind cutout
28 3/4” (73.0 cm)
3 1/4 inch
side panel
ERV3015
downdraft
3/8” min. (1.0 cm) space
required behind ERV3015
chassis to clear stiffener
H
Range trim resting
on countertop
Cutout tolerances: +1/16” (+1.6 mm), -0
Summary of Contents for Distinctive DR30D
Page 23: ......
