Care and maintenance - Cooktop
English
English
80
81
Care and maintenance - Cooktop
Care and maintenance - Cooktop
Burner caps and heads
NOTE
Before removing the burner caps and heads, remember their size and location. Replace
them in the same location after cleaning.
Wash burner caps and burner heads in warm, soapy water and rinse with clean running
water. You may scour with a plastic sponge or pad to remove burned-on food particles.
Use a sewing needle or paper clip to unclog the small holes in the burner head, if required.
CAUTION
• Do not wash any burner parts in a dishwasher.
• Do not use steel wool or scouring powders to clean the burners.
Brass burner head
Brass burner cap
NOTE
• The brass parts of your burner will change color. However, this will not affect
performance.
• After cleaning, check that all burner ports are unclogged.
• You may swap out the original burner caps for porcelain caps if desired.
• To remove burned-on grease, soak the brass burner cap in a solution of water and
either 1 tablespoon of white vinegar or 1 tablespoon of lemon juice. Do not use a
metallic brush while cleaning it. It can damage the brass parts.
Burner bases
CAUTION
The burner bases are not removable; do
not try to disassemble them.
Make sure that no water gets into the
burner bases and the brass gas orifices.
Wipe them clean with a damp cloth, being
careful not to mar or deform the bases.
Make sure the bases are completely dry
before using the cooktop.
Electrodes
WARNING
Do not turn on the valve while touching the electrode. Electric chock might occur.
CAUTION
Do not attempt to remove the electrode from the cooktop or burner bases.
01
02
01
Metal part
: Clean this metal part
02
White ceramic part
: Do not clean this
white ceramic part with an emery
board
You should never be cooking while you’re
cleaning the cooktop.
Make sure the white ceramic electrodes
are clean and dry. Clean the metal portion
with a soft cloth. Do not clean the igniters
with water.
Before reassembling the surface burners,
push down gently on each of the white
ceramic electrodes to make sure they are
pressed against the burner bases.
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 80-81
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 80-81
2023-01-17 오후 3:01:59
2023-01-17 오후 3:01:59