Care and maintenance - Cooktop
English
English
82
83
Care and maintenance - Cooktop
Care and maintenance - Cooktop
Burner head and cap replacement
Dual Burner head / caps
1.
Orient the burner head so the electrode
opening aligns with the electrode itself.
2.
Install the burner head so the electrode
passes through its opening in the head.
Verify that the burner head lies flat on
the cooktop.
3.
Match the burner caps to the burners
by size, and then re-install the caps on
the burner heads.
CAUTION
Each cap fits on a specific burner head.
Verify that each cap is installed and lies
flat on the correct head.
Round Burner head / caps
1.
Put the burner heads on the burner
bases. The bottom of the head fits
inside the top of the burner base.
2.
Turn the head until it drops in place,
then wiggle it to ensure it is seated
properly.
3.
Place the burner caps on the burner
rings. The ridge on the bottom of each
cap fits around the top of the ring.
CAUTION
Verify that all burner parts are properly
seated.
NOTE
After installing the burners, verify that
they will work properly.
Improperly installed components will
result in poor ignition or uneven flames
as shown in the illustration at left. If
the burner shows uneven flame and
excessive yellow flame, shut off the burner
immediately and let the burner cool down.
Readjust the burner caps and try lighting
the burner again. A good flame shows all
blue and even flame around the burner.
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 82-83
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 82-83
2023-01-17 오후 3:02:00
2023-01-17 오후 3:02:00