English
English
104
105
Troubleshooting
Troubleshooting
Troubleshooting
Problem
Cause
Action
Food does not
broil properly in
the oven.
The oven controls are not
set properly.
See page
.
The oven door was not
closed during broiling.
Close the oven door during broiling.
The rack has not been
properly positioned.
See the broiling guide on page
Information codes
Oven
Displayed
code
Possible cause
Solution
C-d0
This code occurs if the control key is
short for 1 minute.
Clean the buttons and make sure
there is no water on/around
them. Turn off the oven and try
again. If the problem continues,
contact a local Dacor service
center.
C-d1
This code occurs if the door lock is
mispositioned.
Turn the burner knob to
Off
,
and then restart the oven. If the
problem persists, disconnect all
power to the oven for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
C-F0
This code occurs if communication
between the Main and Sub PBA is
interrupted.
C-F2
This code occurs if communication
between the Main and Touch is
interrupted.
C-20
The oven sensor is open when the
oven is operating.
The oven sensor is short when the
oven is operating.
C-21
This code occurs if the internal
temperature rises abnormally high.
Restart the appliance.
Displayed
code
Possible cause
Solution
C-22
The Sub PCB sensor is open when
the oven is operating.
Turn both the mode and
temperature selector knobs to
Off
, and then restart the oven. If
the problem persists, disconnect
all power to the oven for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
The Sub PCB sensor is short when
the oven is operating.
C-23
The temperature probe sensor is
short when the oven is operating.
Turn the burner knob to
Off
,
and then restart the oven. If the
problem persists, disconnect all
power to the oven for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
C-30
The PCB sensor is open when the
oven is operating.
The PCB sensor is short when the
oven is operating.
C-31
This code occurs if the PCB
temperature rises abnormally high.
Call for service
C-A2
The cooling motor is operating
abnormally.
Call for service.
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 104-105
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 104-105
2023-01-17 오후 3:02:03
2023-01-17 오후 3:02:03