16
Before You Call for Service
Problem Solution Guide
Before you call for service, please review the
Problem Solution Guide
below.
Problem
May Be Caused By
What to Do
Flashing lights on
control panel
HEAVY
,
NORMAL
,
LIGHT
,
QUICK
and
RINSE
lights
flashing: Too much water in
dishwasher
Call for service.
LIGHT
light flashing:
Water
inlet problem
Make sure water valve is turned on. Make sure
water supply line to dishwasher is not kinked.
QUICK
light flashing:
Valve
leakage
Shut off water supply valve and call for service.
AUTO
and
HEAVY
lights
flashing: blocked drain
Check for kinked drain hose. Disconnect end of
drain hose. Check for debris in hose or any other
part of drain system/plumbing. Check to see if filter
system is clogged (see below).
AUTO
and
NORMAL
lights
flashing: clogged filter
Clean entire filter system. See page 13.
WASH TEMP
and
DRY
cycle
lights flashing when a button is
pressed: child safety lock on
See page 11.
Dishwasher will not start
(control panel is not lit)
Main power switch is off
Open door and turn on main power switch on top
of door before selecting cycle. See page 10.
Power is disconnected
Make sure power is on at the circuit breaker panel
and that the power plug is properly connected to
electrical outlet (if applicable).
Blown fuse or tripped circuit
breaker
Replace fuse or reset circuit breaker. Remove
other appliances from circuit.
Power failure
Contact electric company.
Dishwasher will not start
(control panel is lit)
Door not completely closed
Gently push in on front of door until you hear a
click.
Controls not set
Make sure dishwasher controls are properly set
and door is closed. See Page 10.
Child safety lock is engaged
(
WASH TEMP
and
DRY
cycle
lights flash when buttons are
pressed)
Disengage child safety lock. See page 11.
No water supply (delicate light
may flash on control panel)
Make sure water valve is turned on. Make sure
water supply line to dishwasher is not kinked.
Drain pump clogged (a loud
buzzing sound is heard, lights
on control panel may flash)
Disconnect power plug and clean entire filter
system. See page 13. Reconnect power and
attempt to restart. If problem persists, shut off the
water valve, disconnect power and call for service.
Overfilling/leakage
Contact Dacor Customer Service.
Dishwasher has detected
a fault condition (lights on
control panel are flashing)
See
Flashing lights on control panel
above.
