7
m
ove
u
niT
To
f
inal
p
osiTion
IMPORTANT:
To prevent floor damage, make sure levelers are
raised (not touching the floor) and the unit is on rollers before
moving.
◊
Place top of cardboard carton or plywood under refrigerator.
Remove unit from dolly.
◊
Move the refrigerator straight back and evenly into the rough
opening. Verify that the water tubing is not kinked and the
power cord is not kinked.
i
nsTallaTion
i
nsTRuCTions
l
eveling
CAUTION
To protect property and refrigerator from damage, observe the following:
•
Protect vinyl or other flooring with cardboard, rugs, or other protective
material.
•
Do not use power tools when performing leveling procedure.
To enhance the appearance and maintain performance, the refrigerator
should be level.
NOTE
Complete all electrical and water supply connections before leveling.
Materials Needed:
• 3⁄8” hex head driver
• Carpenter’s level
1. Remove toe grille.
• Grasp firmly and pull outward to unclip.
2. Using hex head driver, turn the front adjustment screws (A) on each
side to raise or lower the front of the refrigerator.
3. Using the hex head driver, turn each of these adjustment screws (B)
to raise or lower the rear of the refrigerator.
4
. Using the carpenter’s level, make sure front of refrigerator is 1⁄4”
(6 mm) or 1⁄2 bubble higher than back of refrigerator and that the
refrigerator is level from side to side.
5. Turn stabilizing legs (C) clockwise until firmly against floor.
6. Turn adjustment screws (A) counterclockwise to allow the full weight
of the refrigerator to rest on the stabilizing legs.
7. Replace the toe grille.
• Align the toe grille mounting clips with the lower cabinet slots.
•
Push the toe grille firmly until it snaps into place.
The importance of the proper installation of your Dacor Built-In
Refrigerator cannot be overemphasized. Proper installation is the
responsibility of the homeowner.
IMPORTANT:
To ensure a safe and proper installation, the
following checklist should be competed by the installer to ensure
that no part of the installation has been overlooked.
Any questions or problems with this installations should be
directed to your Dacor dealer or the Dacor Customer Service
Team at (800) 793-0093. You may also visit our web site at www.
Dacor.com.
Are all leveling legs extended down to make contact with the
floor? Is the unit level?
Is the power cord plugged into a properly grounded
dedicated 3-prong non-GFCI outlet, which had been installed
in accordance with all applicable electrical codes?
Is the water supply connected? Have you checked for leaks?
Has the kick-plate been installed properly?
Has the warranty been activated on-line or warranty card
filled out and mailed?
i
nsTallaTion
C
heCklisT
