PLANNING
GUIDE
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
11.14
42” and 48” Wide
Built-In Refrigerators
EF42DBSS, EF42NBSS, EF48DBSS, EF48NBSS,
IF42DBOL, IF42NBOL, IF48DBOL, IF48NBOL
1/6
O
pening
D
imensiOns
To avoid tipping during use, the solid soffit must be within 1”
◊
(2.5 cm) maximum above the refrigerator. If the solid soffit
is higher than 1” (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the
rear wall studs 80” to 90” (203 cm to 229 cm) above the floor.
See installation instructions for more information.
NOTE
: A clearance of ¹⁄
2
” (1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
4"
(10.2 cm)
83
¹/
2
" (212.1 cm) min.
84
³/
4
" (215 cm) max.
to bottom of solid soffit
24"
(60.96 cm) min.
77"
(196 cm)
A
Width
(see chart following)
Revised
04/22/08
"
(1.3 cm)
1
/
2
Model Series
Cutout Width A
EF42, IF42
41½” (105.4 cm) to 41¾” (106.1 cm)
EF48, IF48
47½” (120.7 cm) to 47¾” (121.3 cm)
NOTE
: Flooring under refrigerator must be at same level as the
room. Face of cabinetry must be plumb.
A grounded 3 prong electrical outlet should be placed within
◊
4” (10.2 cm) of the right side cabinets or end panel. See
Electrical Requirements
for more information.
The water shutoff should be located in the base cabinet on
◊
either side of the refrigerator or some other easily accessible
area. If the water shutoff valve is not in the cabinets, the
plumbing for the water line can come through the floor or
the back wall. See
Water Supply Requirements
for more
information.
See Page 11.15
