8
Using two (2) of the provided #8 x 1/4 screws, attach
10.
the bracket to the backguard as shown. Each screw
threads into the backguard through the hole in the back
of the bracket.
Install the rear trim piece on the back side of the
11.
backguard with the two (2) remaining #8 x 1/4 screws.
Adjust the Range Height
For stand alone configurations, raise the range until
1.
the top of the trim around the cooktop is at least
the same height as the countertop. For self-rimming
configurations, raise the range until the bottom of
the trim surrounding the cooktop is even with the
countertop. To adjust the height, turn the foot on the
bottom of each leg as shown below.
Use a level to make sure that the range does not tilt
2.
front to back or side to side. Readjust the legs as
necessary.
Self-Rimming Trim Installation (cont.)
Remove and retain the two (2) hex head screws from
8.
the top back corners of the sides of the chassis as
shown.
Using the hex screws removed in step 8, attach the
9.
backguard support brackets as shown. The long end of
each bracket goes toward the front of the range. Slip
the back side of the bracket over the back side of the
backguard.
Installation Instructions
up
down
Slide bracket
around back
