9
Door Removal
Remove the door to make the range easier to move during
the installation process.
WARNING
Do not attempt to disengage the hinge catches with
•
the door removed from the oven. The hinge springs
could release causing personal injury.
Do not lift or carry the oven door by the door handle.
•
Open the door to its fully opened position.
1.
Use a flat blade screwdriver to rotate the catch over the
2.
retaining arm on both hinges.
Lift the oven door to about a 15° angle from the vertical
3.
position.
Hold the door with both hands just below the handle.
4.
Pull the door up and away from the oven.
Door Gripping Points
Install the Anti-Tip Bracket
Locate the anti-tip foot on the back of the range and
1.
turn it until the bottom of it is 1/16” (2 mm) off the floor.
Locate the anti-tip bracket included in the parts box.
2.
Install the anti-tip bracket on the floor using the four (4)
3.
included screws. See the diagram below.
Anti-Tip Bracket Placement
A
4 1/4” (10.8 cm)
B
2 1/2” (6.4 cm)
Installation Instructions
A
B
Side of range
Back of range
Retaining arm
Catch
Back of Range
Anti-Tip Foot
