6
Plug the three-prong plug from the appliance
into the properly grounded and polarized wall
receptacle.
Three-Prong Plug
Three-prong grounded receptacle
and cover plate
Three-Prong Plug and Receptacle
Verifying Proper Operation
WARNINGS:
1. If the cooktop fails to operate
properly, ensure that the
electrical power supply and
gas supply are turned on and
that all installation steps have
been carefully followed. Call
a qualified service technician
if the cooktop still does not
operate properly.
2. The cooktop and shut-off valve
must be disconnected from the
gas supply piping during any
pressure testing exceeding
1/2 pound per square inch (3.5
kPA).
3. The cooktop must be isolated
from the gas supply piping
by closing the shut-off valve
during any pressure testing at
or below 1/2 pound per square
inch (3.5 kPA).
Before beginning the test procedure, ensure
that the gas supply is turned off at the shut-off
valve, all cooktop control valves are in the “OFF”
position, and all burner rings, burner caps, and
grates are properly positioned on the cooktop.
Rotate one knob at a time counterclockwise to
the “HIGH” position. Verify that all ignitors spark
continuously, then return the knob to the “OFF”
position. Repeat for all knobs.
Turn on the main gas supply to the cooktop by
opening the gas shut-off valve. Test each burner
separately by pressing and turning one control
knob at a time counterclockwise to the “HIGH”
position. All ignitors will spark continuously, but
only the burner with gas flowing to it will ignite.
(It will take approximately four seconds for
ignition to occur, at which time all ignitors will
stop sparking. If ignition does not occur within
four seconds, turn off the knob, wait for at least
two minutes to allow any gas to dissipate, then
repeat this ignition test.) The control knob can
then be rotated counterclockwise from “HIGH” to
“LOW” to adjust the flame height progressively.
Repeat the ignition test for all burners.
Light & high position
Off position
Low position
Burner indicator light
Gas Control Knob
When installed properly, the flame will be steady
and quiet. It will also have a sharp, blue inner
cone that will vary in length proportional to
the burner size. Flame adjustment will not be
necessary.
Read and understand the accompanying
Use & Care Manual prior to cooking with this
appliance. The Use & Care Manual contains
additional important safety, service and warranty
information.
