Page 9-23
S
ECTION
9 - C
OMPONENT
R
EPAIR
Broil Element (continued)
Place the broil element into the oven chamber
with the glass facing down and the terminals
toward the back of the oven.
Lift the back of the element up and reconnect
the broil element wires to the terminals
on the broil element assembly. Make sure
that the wires are connected to the proper
terminals.
Insert the broil element assembly into the
hole in the oven ceiling while pushing the broil
element wires into the access hole toward the
back.
Hold the broil element assembly in place
with one hand while replacing the eight (8)
existing screws that hold it in place.
Reinstall the racks.
Reinstall the oven door as described on page
8-2.
Test the oven to ensure that repairs were
properly completed.
Bake Element
Left oven on Model ER48D:
Turn off the gas supply at the supply valve
and power to the range at the junction or fuse
box.
Remove the oven door as described on page
8-1. Remove the oven racks.
Remove the convection filter
A
from the
back wall of the oven by lifting it up and out.
Remove the four (4) screws that hold the
convection baffle
B
to the back of the oven
and remove it.
Remove the screws that hold the bake
element
C
in place. Pull the wires through
the back wall with a gentle rocking motion
to prevent them from disconnecting from the
element inside the back wall. Disconnect the
wires from the element after they have pulled
through the wall.
When replacing the element, connect the
wires to the element and gently push them
into the holes on the back oven wall as you
reposition the element. Reattach it using the
existing screws.
Reinstall the convection baffle and filter.
Reinstall the oven racks. Reinstall the oven
door as described on page 8-2.
Test the oven to ensure that repairs were
properly completed.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
A
B
C
