6
Cooktop Assembly
The burner rings spread the flame evenly around
the burner cap. All burner parts must be properly
seated for proper burner lighting and operation.
To assemble the burners:
1. Remove the burner rings, burner caps and grates
from their shipping packages.
2. Install the burners as shown below. Gently twist
each piece back and forth after installation to
make sure it is properly seated. A small gap
below the burner ring is normal when installed
properly.
3. Gently set each grate on top of the spill tray. Put
the legs of each grate inside the corresponding
dimples.
Setting Up the Range
SimmerSear Burner Assembly
(left front and right front burners only)
Standard Burner Assembly
(left rear, right rear and both center burners)
STEP 1:
Install burner
head. Put locating tab
in keyed hole.
STEP 2:
Install burner
ring. Line up ring tabs
with head slots.
STEP 3:
Install burner
cap. Ridge on cap must
surround top of ring.
Ridge on bottom
of burner cap
Burner ring
Burner head
Burner base
Keyed hole
STEP 1:
Put
burner ring on top
of head.
STEP 2:
Turn ring
until it drops into
place.
STEP 3:
Install
burner caps.
Ridge on cap must
surround top of ring.
Burner ring
Burner head
Ridge on
bottom of
burner cap