7
Operating the Range
SimmerSear Burner Assembly
(left-front burner only)
Standard Burner Assembly
(left-rear, right-rear, right-front burners)
Install burner
head. Put locating tab
in keyed hole.
Install burner ring.
Line up ring tabs with head
slots.
Install burner caps.
Ridge on cap must surround
top of ring.
Ridge on bottom of
burner cap
Burner ring
Burner head
Put burner
ring on top of head.
Turn ring until it
drops into place.
Install burner
caps. Ridge on cap must
surround top of ring.
Burner ring
Burner head
Ridge on bottom
of burner cap
Assembling the Cooktop
WARNING
Operate the cooktop only when all burners are properly assembled.
1. Remove the burner rings, burner caps, and grates from their
shipping packages.
2. Install the burners as shown. When installing burner parts, twist
each piece back and forth slightly until it drops into place. The
burners do not work properly unless all pieces are properly seated.
3. Gently set the grates on the spill tray so each foot rests in its
corresponding dimple.