27
MMDV30S
MMDH30S
Back cover
Exhaust duct
screws
Top plate
Right side panel
Left side panel
Air cover
Cavity
Male GND
terminal
MICROWAVE DRAWER DISASSEMBLY
Fig. 1
. Before removing Microwave Drawer, take measures to protect
the Drawer louver by either removing the louver or by letting
the louver over hang off flat protected surface
(Fig 1)
.
2. Open the Drawer to access the 4 mounting screws holding the
unit on to the wall or cabinet opening.
(Fig 1)
.
3. Close Drawer and carefully pull the unit out from opening and
unplug the power supply cord.
4. Remove top cover.
(Fig 2)
.
5. Remove air cover from back of unit, then both side cabinets.
(Fig 2)
.
6. Remove exhaust duct and back plate.
(Fig 2)
.
NOTE:
You now have access to various components for the Drawer.
WARNING: Follow all safety precautions as stated at the beginning of this Service
Manual before proceeding!
Fig. 2
Louver
Note: When removing the back plate, un-hook
the green ground wire terminal.
