28
MMDV30S
MMDH30S
At this point, you will have access to all parts of the Microwave Drawer.
7. To remove the Control Panel Frame Assembly,
remove the 9 screws holding the C/P frame to the cavity.
(Fig 3)
.
With the C/P frame assembly now loose, you can unplug all wires.
Fig. 3
POWER CORD REPLACEMENT
Un-hook/Attach Black AC Wire to Top Terminal
Attach White AC Wire to Bottom Terminal
Un-hook/Attach Ground to metal Tab on Back Plate
Un-hook/Attach White AC Wire to Bottom Terminal
Noise
Filter
Unit
Back Plate
. Un-hook the black and white AC terminals from the Noise Filter PWB.
(Fig 4)
.
2. Attach the black and white AC terminals from the new Power Cord to the Noise
Filter as shown in figure 4.
Fig. 4
Note: The green ground wire terminal can be attached when reassembling the back plate to the drawer cavity.
